Multifunctional Waterproof LCD Display S866 and Brushless Motor Controller for Electric Scooter
Motor style: Brushless
Rated voltage: 24V 36V 48V
Rated power: 500W
Current: 25A±1A
Controller Size: 121x50x30mm
Use for: e-scooter, e-car etc.
How to use self-study:
When using the controller and the motor to work for the first time, should first use self-study wire.
Step 1. Connect the motor wire, Hall wire, battery wire, and other function wires.
Step 2. connect the self-study wire, the motor rotates forward, let it learn automatically for 10-20 seconds, disconnect the self-study wire, connect to other function wires, complete the self-study, and do not need to use it in the future.
How to set the P07:
1. If your motor have speed sensor wire ( some is the white wiring in hall), the P07 set to 1.
2. If your motor without speed sensor wire ( hall is 5 wiring) , so you must know your motor magnet number and motor gear ratio.
P07= magnet * gear ratio ( ex: magnet =20 , gear ratio= 1:4.5 , so P07 set to 20*4.5=90
Headlight display
(Turn-on the lights power) Press and hold the "+" button 3 seconds to turn on/off ;
Set up operation(Only need to set P03, P06, P07, P10, P13)
◆ Press "+" and " -" button together 3 seconds to enter the setting interface
※ Press "M" button to enter setting item;press up and down button to select parameter
P01: meter backlight
P02: Mileage unit, 0:KM 1:MILE
P03: Voltage level, Base operating voltage
P04: Sleep Time, 0: no-sleep, unit: min
P05: Assist position,0:3,1:5,mode
P06: Wheel Diameter, unit: inch Accuracy: 0.1
P07: Number of speed magnets , range :1-100 ( Note: here only for set speed display, doen't affect the actual speed)
P08: Speed Limit, Range:0-50km/h,50: means Unlimited speed (When speed big than setting speed, Turn off the PWM output)
P09: Zero or non-zero start, 0:zero start 1:non-zero start
P10: Drive Mode setting: 0 : Power Drive, throttle invalid ( Assist power)
- Electric throttle Drive mode, Assist invalid
- Both assist and throttle are effective
P11: Boost sensitivity setting, range: 1-24
P12: Boost start strength setting, range: 1-5
P13: PAS Assist Type Setting.(5/8/12) Single Hall PAS: set to 5 /8 Double Hall PAS: Set to 12
P14: P15:Not opened functions
P16: ODO clear; long press up button 5 seconds to clear
