LED Display Throttle TF100 5PIN for KuGoo M4

The TF-100 is a trigger throttle and LCD display that is used electric scooter manufacturers around the world. It has been used by nearly every brand including Apollo, EMOVE, Fluid Freeride, Joyor, and Kaabo, among others.

This LCD throttle interfaces with the controller and battery and should not to be confused with being a controller itself — a beefier component buried deeper with the electric scooter. The TF-100 provides a readout of speed, odometer, trip, mode, and battery remaining. It features buttons that allow you to power your scooter on, control the lights, and adjust a cryptic list of electric scooter settings known as p-settings or program settings. These settings dictate everything from regenerative braking strength to max throttle power to motor pole configuration. If you’re looking for specific settings for your electric scooter, see our database of electric scooter p-settings.

Features:
The TF-100 features a large, back-lit (typically color) acrylic-covered LCD, two buttons (mode and power), and a trigger-style throttle. The trigger throttle works well, but we and others have noted that it’s not the most comfortable for longer trips due to the very stretched out position it puts your finger in.

The typical TF-100 is not waterproof and we’d even venture to say that it’s barely water resistant as no special measures have been taken to seal the ABS case up from the elements. There are some variants of the TF-100 that seem to have more serious water-resistance measures taken, but most commonplace one you see won’t have those.

All versions of the TF-100 use a 5- or 6-pin connector that communicates with the controller via the UART protocol over TX and RX lines.

USB Port
The TF-100 also features a USB port that can supply 5V at around 500 mA to 1000 mA of current. It’s primarily intended for flashing the unit, but it could potentially be used for charging USB accessories though we don’t advise it. The PCB is not robustly designed and current-thirsty USB devices risk frying your throttle unit.

Specifications:

MODEL: TF100 5PIN
Dimention: 100x95x30mm
Fuction: Speed, PAS Level (0-9), TRIP/ODO, Headlight, Walk, Mile/Km, Error Alarm, Parameters setting, Battery Level
Protocol: UART #1
Installation: ø22.2mm
Supply voltage: 24V/36V/48V Max (Please set P03 on screen for choose voltage )
For model: e-bike, electric scooter, etc